Use and Care Manual

ManualsBrandsSpruce & Spring ManualsBar Furniture27 in. Cody Saddle Brown High Back Metal Swivel Counter Stool with Faux Leather (Set of 2)

Table Of Contents

Page 1 of 7

PLEASE READ AND KEEP FOR FUTURE REFERENCE.

THIS ASSEMBLY MANUAL CONTAINS IMPORTANT SAFETY INFORMATION.

CAUTION

BS72015 Assembly Manual

Counter & Bar Height Swivel Stool

Assembly Manual

BS72015

Summary of content (7 pages)

PAGE 1
Assembly Manual BS72015 BS72015 Assembly Manual Counter & Bar Height Swivel Stool CAUTION THIS ASSEMBLY MANUAL CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND KEEP FOR FUTURE REFERENCE.
PAGE 2
Assembly Manual BS72015 Ax1 Bx1 Cx1 Dx1 Ex1 Fx1 Gx1 Hx4 Ix5 M6*35mm Jx2 Mx11 Px4 Kx4 M6*18mm Nx11 M6*30mm Lx4 M6*16mm M6*25mm Ox1 M6 M6 4# Ø15mm Please read through the instructions below to familiarize yourself with the parts and steps before assembly. Note: Do NOT use power tools for assembly.
PAGE 3
Assembly Manual BS72015 ASSEMBLY INSTRUCTIONS Upack and place seat (A), back (B), back frame (C), legs (D&E), foot rest (F) ,and swivel plate (G) on a clean surface. Attach leg (D) to leg (E), using bolt (I ), lock washer (M), flat washer (N) and allen wrench (O). Note: Do NOT fully tighten yet. A O C I N B M D D F E E Loosely attach bolts (K) one by one and keep them loose. Do not fully tighten. After loosely attach the first bolt, move on to the diagonal bolt.
PAGE 4
Assembly Manual BS72015 Fully tighten bolt (I) in step 1 with allen wrench (O). Then attach swivel plate (G) to assembled legs in step 2, using bolts (I), lock washers (M), flat washers (N) and allen wrench (O). Note: Do not fully tighten yet. O O I M N G x4 Put assembled legs in step 3 on a flat surface. Push legs up or down as necessary to level. Once level, tighten all bolts.
PAGE 5
Assembly Manual BS72015 Attach back frame (C) to backrest (B), using bolts (L) and allen wrench (O). Tighten all bolts. O L B x4 C Attach back frame (C) to seat (A), using bolts (J), lock washers (M), flat washers (N) and allen wrench (O).
PAGE 6
Assembly Manual BS72015 Turn assembled leg base in step 4 upside down and attach it to assembled seat in step 6, using bolts (H), lock washers (M), flat washers (N) and allen wrench (O). Tighten all bolts. O H M N x4 Complimentary felt pads (P) are included to help protect your floor or make the stool slide easier.
PAGE 7
Assembly Manual BS72015 Turn assembled stool upright and place on a flat surface. Note: Each leg has an adjustable foot leveler to help level your stool. Foot levelers Assembly complete. Enjoy. CAUTION: PINCH POINT. Please keep hands clear during swivel.