Instructions / Assembly

IN018 RevAA 0923

53 Saber Way, Ward Hill, MA 01835 | radonaway.com

Step 6: Make electrical connection to fan (Fig. 9). Ensure any metal filing used in the installation is properly

grounded. A p

astic cable connector such as a T&B #3300 may be used to avoid any filing grounding

problem. Observe the proper wiring connections (See Section 5.0). Note that the fan is not intended for

connection to rigid metal conduit.

Note: Some of our fan models use motors that do not utilize a ground wire. This wire configuration is safe and

allowable under our ETL safety listing. If the fan being installed was constructed with the 2-wire configuration

(no ground), the ground wire from the Line supply should be capped with a wire nut inside the electrical box at

the fan.

Fig. 4 Fig. 5 Fig. 6

Fig. 9Fig. 8Fig. 7

7.0 INSTALLATION FIGURES