UNDERCOUNTER ICE MAKER Model #: IM-600US INSTRUCTION MANUAL Be sure to stand the icemaker upright for at least 24 hours prior to plugging it in. Installation by a licensed plumber only. Improper water line connection may result in flooding.
TABLE OF CONTENTS Page ICE MAKER SAFETY …………………………………………………………………2 ELECTRICAL CONNECTION ……………………………………………………....2 SAFETY PRECAUTIONS ……………………………………………………………..3 TECHNICAL INFORMATION ………………………………………………………..3 COMPONENTS ………….………………………………………….…………………4 INSTALLATION INSTRUCTIONS ……………………………………………….5-7 Location requirements Installation Reversing the door Connecting the water supply Installation types OPERATING YOUR ICEMAKER ……………………………………………….
FOLLOW THESE BASIC PRECAUTIONS TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK, OR INJURY WHEN USING YOUR ICE MAKER. WARNING • • • • • • READ ALL INSTRUCTIONS BEFORE USING THE ICE MAKER. DANGER: RISK OF CHILD ENTRAPMENT. CHILD ENTRAPMENT AND SUFFOCATION ARE NOT PROBLEMS OF THE PAST. JUNKED OR ABANDONED APPLIANCES ARE STILL DANGEROUS. BEFORE YOU THROW AWAY YOUR ICE MAKER: TAKE OFF THE DOOR. NEVER ALLOW CHILDREN TO OPERATE, PLAY WITH, OR CRAWL INSIDE THE APPLIANCE.
• SAFETY PRECAUTIONS Do not connect or disconnect the electric plug with wet hands. Never clean the icemaker with flammable fluids. These fumes can create a fire hazard or explosion. Do not store gasoline or other flammable vapors/liquids in the vicinity of this or any other appliance. Always turn unit off and disconnect power and water line before servicing. Replace all panels after servicing or maintenance.
NOTE ON ICE STORAGE This type of icemaker produces crystal-clear, gourmet ice cubes. An insulated ice storage bin is built into the unit. When the bin is filled with ice to its max capacity, the icemaker will automatically shut off. The ice in the bin will slowly melt and go out the drain. Once the amount of ice is reduced below it max capacity, the icemaker will automatically start again.
INSTALLATION INSTRUCTIONS • • • • • BEFORE USING YOUR ICE MAKER Remove exterior and interior packing materials. Do not remove any permanent instruction labels or data label on the icemaker. Remove tape and glue from the icemaker before using. Tape or glue residue can be easily removed by rubbing a small amount of liquid dish soap over the adhesive with your fingers. Wipe with warm water and dry.
• • • • • stick together. De-ionized water is not recommended. Place the icemaker on a level surface that is strong enough to support the unit when it is fully loaded. Remember that the unit will be significantly heavier once it is operational and fully loaded. Level the unit by adjusting the legs at the front of the icemaker. The unit should be located on a firm and level surface. If needed, adjust the height of the icemaker by rotating the leveling leg.
CONNECTING THE WATER SUPPLY WARNING IMPROPER WATER LINE CONNECTION MAY RESULT IN FLOODING YOU MUST USE A LICENSED PLUMBER REVIEW STATE AND LOCAL PLUMBING CODES BEFORE INSTALLATION • • • • • The water supply should be ready at the point of installation. The water supply pressure should be 15-psig minimum with static pressure no more than 80 psig. A wall outlet directly behind the icemaker will make installation easier. Be sure pipes are not pinched or kinked or damaged during installation.
OPERATING YOUR ICE MAKER OPERATION CHECK LIST All packing material and tape removed? Ice storage bin cleaned? Unit properly installed by a licensed plumber with proper drainage? Is unit leveled? Ambient temperature is between 50°F and 100°F? Supplied water temperature is between 41°F to 90°F year round? Water pressure is 15 psig minimum and static pressure no more than 80 psig? Clearance around the unit for proper air circulation? Power supply checked and tested against the nameplate ra
How the unit uses water The icemaker begins with a fixed charge of water that is contained in the water trough. As the water flows to the freezing evaporator surface, water that does not contain mineral impurities will freeze and stick to the ice cube molds. Water containing impurities will fall back into the trough. During the ice making process, fresh water enters the trough continuously as water from the trough freezes continuously on the evaporator.
CARE AND MAINTENANCE FAILURE TO UNPLUG THE ICE MAKER PRIOR TO CLEANING, MOVING, OR SERVICING COULD RESULT IN ELECTRICAL SHOCK OR PERSONAL INJURY. CLEANING YOUR ICE MAKER Periodic cleaning and proper maintenance will ensure efficiency, performance and long life. Exterior Cleaning The door and cabinet may be cleaned with a mild detergent and warm water solution (1oz dishwashing liquid to 2 gallons of warm water). Do not use solvent based or abrasive cleaners. Use a soft sponge and rinse with clean water.
switch to the OFF position. 2. Remove all ice from the storage bin. 3. Keep the icemaker connected to the water supply. Pour 8 oz. of a Nickel-Safe Ice Maker Cleaner into the water trough. Wait five minutes and set switch to WASH position. The unit will begin the automatic clean mode. Note: Nickel-safe ice maker cleaner can be purchased locally at any home improvement store. 4. Allow 30 minutes for proper cleaning. After cleaning, set switch to OFF position.
TROUBLESHOOTING GUIDE PROBLEM POSSIBLE CAUSE OR FIX The machine won’t operate Unit is not plugged in. The fuse is blown – replace fuse. Switch is set at OFF position Ice storage bin is full. Water does not feed Water supply tap is turned off The water supply pipe is not properly connected. Machine is making ice, but bin does not fill up with ice. Condenser is dirty and needs to be cleaned. The airflow to the icemaker is obstructed – check ventilation area around the unit.
Your Guarantee If this product is found to be faulty as a result of faulty materials or workmanship within one year from date of purchase, it will be repaired free of charge. This guarantee is subject to the following terms: • Sunpentown must be notified of the fault. • Proof of purchase must be presented to Sunpentown’s nominated representative. • The warranty will be void if the product if modified, misused or repaired by an unauthorized person.