Instruction Manual 3.3 CU. FT.
Contents 1. SAFETY WARNINGS............................................................................................................ 1 2. INSTALLTION...................................................................................................................... 2 3. PRODUCT OVERVIEW ........................................................................................................ 4 4. OPERATION.............................................................................................
1. SAFETY WARNINGS Caution: risk of fire 1) WARNING―Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction. 2) WARNING―Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer. 3) WARNING―Do not damage the refrigerant circuit.
2. INSTALLTION 2.1 Location When selecting a position for your unit, please make sure the floor is flat and firm. The room should be well ventilated with an ambient room temperature between 61°F and 100°F. Avoid locating your unit near a heat source, e.g. cooker, boiler or radiator. Also avoid direct sunlight as it may increase the electrical consumption. Extreme cold temperatures may cause the unit not to perform properly. This unit is not designed for use in garage or outdoor installation.
) Slide the door downwards and off the top hinge pin. Lift and remove door, place to side. 6) Remove the two screws from top bracket and transfer to the other side. You will need to first remove the plastic caps on the other side. 7) Slide the door back onto the top hinge, be sure the door is the right way up. 8) Screw the bottom hinge into place on the new side. 9) Place the foot on the other side. 10) Cover the top of door hinge with plastic cover by gently pushing into position.
2.6 Before Using Your Unit Before placing any food in your unit, turn it on and wait for 24 hours to make sure it is working properly. This will also allow the unit to fall to the correct temperature. Your unit should not be overfilled. • • Before Plugging - Please check that you have a wall socket that is compatible with the plug supplied. Before Turning On – Please allow unit to sit for a minimum of 2 hours, allowing the coolant to settle. 2.
4. OPERATION 4.1 Adjusting the Temperature • The temperature control knob is located on the right, below the freezer compartment. • OFF = power off • • • • MIN = Least cool temperature setting MED = Normal operation (suggested setting for most situations) MAX = Coldest temperature setting During high ambient temperatures e.g. on hot summer days, it may be necessary to set the thermostat on the coldest setting (MAX).
5. CLEANING 5.1 Defrosting Frost may accumulate on the inner rear surface of the appliance, which will automatically defrost during compressor cycle. Water is channeled via the drain hole to the collection tray above the compressor where it will evaporate. Please ensure the drain hole is checked and cleaned on a regular basis so water can exit the storage compartment. Do not use Mechanical Devices to Defrost refrigerator. 5.
7. Troubleshooting The following issues can be handled by the user. If problem persists, please contact Sunpentown Customer Service at 1-800-330-0388. Unit is not plugged in. Check outlet and circuit. No power Low voltage. Power failure power. Odorous foods should be closely wrapped. Check for any rotten food. Odor Clean the interior. It is normal for the unit to operate for longer periods of time during the hotter days when ambient temperature is higher.
• • • Wrap foods properly and wipe containers dry before placing them in the refrigerator. This cuts down on frost build-up inside the appliance. Do not line the storage bin with aluminum foil, wax paper or paper towel. Liners interfere with cold air circulation, making the appliance less efficient. Organize and label food to reduce door openings and extended searches. Remove as many items as needed at one time and close the door as soon as possible. 9. DISPOSAL Old units still have some residual value.
Your Guarantee If this product is found to be faulty as a result of faulty materials or workmanship within one year from date of purchase, it will be repaired free of charge. This guarantee is subject to the following terms: • Sunpentown must be notified of the fault. • Proof of purchase must be presented to Sunpentown’s nominated representative. • The warranty will be void if the product if modified, misused or repaired by an unauthorized person.