Use and Care Manual

The dishes were not
loaded correctly .
See notes in " Loadi ng the Dishwasher Bask e ts ".
Select a more intensive programme.
See" Wash Cycle Table ."
Use more detergent, or change your detergent.
Rearrange the items so that the sp ay can rotate freely.r
Clean and/or fit the filter combination correctly.
Clean the sp ay arm jets. See "Cleaning the Spray
Arms".
r
Use less detergent if you have soft water and select
a shortest cycle to wash the glassware and to get
them clean.
Use a mild abrasive cleaner to eliminate those marks.
Re-loading the dishes properly.
Load the dishwasher as suggested in the directions.
Increase the amount of rinse-aid/Refill the rinse-aid
dispens er.
Do not empty your dishwasher immediately after
washing. Open the door slightly so that the steam can
escape. Begin unloading the dishwasher only once t
he dishes are barely warm to the touch. Empty the low
basket first. This prevents water form dropping off
dishes in the upper basket.
In short programmes the washing temperature is lower.
This also lowers cleaning performance. Choose a
programm e with a long washing time.
Water drainage is m ore difficult with these items.
Cutlery or dishes of this type are not suitable for
washing in the dishwasher.
The programme was
not powerful enough.
Not enough deter gent
was d ispensed.
Item are bloc king
the path of sp ay arms.r
The filter combination
inthebaseofwash
cabinet is not clean or
is not correctly fitted.
This may cause
the sp ay arm jets
to get blocked.
r
Combination of soft
water and too much
detergent.
Aluminum utensils
have rubbed against
dishes.
Dishes block
detergent cups.
Improper loading
Too little rinse -aid
Dishes are removed
too soon.
Wrong programme
selection
Using cutlery wit h
a low-quality coating
If overflow occur s, turn off the main water supply bef ore calling a service.
If there is water in the base pan because of an overfill or small leak,
the water should be removed before restarting the dishwasher.
18
Uns a ti s
-factory
was hin g
res u lt
Uns a ti s
-factory
dry i ng
res u lt
Wh en some malfunctions c ome on, the appliance will d isplay error codes to warn you:
Longer inlet time.
Faucets is not opened, or water intake is restricted,
or water pressureis too low .
Some element of dishwasher leaks . Overflow .