Use and Care Manual

CONTROL PANEL

Control Buttons: whenever a button is pressed, the unit will make a beep sound to indicate that

it is changing modes.

 PUMP: Press to activate pump operation.

NOTE: Make sure the pump drain hose is installed and the continuous drain hose is

removed before activating the pump operation. When the bucket is full, the pump will

begin to work. Refer to the following pages for removal of collected water. Do not use this

operation when outdoor temperature is 32°F or lower .

 FILTER: The check filter feature is a reminder to clean the air filter for more efficient

operation. The Filter indicator will illuminate after 250 hours of operation. To reset after

cleaning the filter, press the Filter button to turn off indicator light.

 FAN: Controls the fan speed. Press to select Turbo (high) or Normal fan speed. Set the

fan to Turbo for maximum moisture removal. When the humidity has reduced or when

quiet operation is preferred, set the fan speed to Normal.

 POWER: Press to turn the dehumidifier on and off.

/ UP(+) / DOWN(-):

• Set humidity level: Press to increase or decrease set humidity level. Range of

adjustment is from 35% to 85% RH, in 5% increments.

• Set timer: Used to set timer, from 0 to 24 hours.

• Continuous operation: To run the unit in continuous mode, press the Down (-) button

until the display reads “CO” for continuous. To stop continuous operation, press the

Up (+) button and set unit to desired RH%.

 TIMER: Press to initiate auto-start and auto-stop feature, works with + and - buttons.