Manualshelf

Use and Care Manual

ManualsBrandsSPT ManualsHeating, Ventilation, and Air Conditioning70-Pint Dehumidifier with Built in Pump and Energy Star
12345678910
5
DISPLAY PANEL
• Displays the set humidity level (from 35% to 85%) or auto-start/stop time (0-24) while
setting, then returns to display actual room humidity level (±5% accuracy), in a range of 30%
RH to 90%RH (relative humidity).
• Displays error codes and protection codes:
o AS – Humidity sensor error. Unplug and plug back in. If error repeats, call for service.
o ES – Temperature sensor error. Unplug and plug back in. If error repeats, call for
service.
o P2 – Bucket is full. Empty bucket and replace.
o EC – Unit malfunction. Please make sure the environment temperature is suitable for
operation.
o E3 – Unit malfunction. Unplug the unit and plug back in. If error repeats, call for service.
o Eb – Bucket is removed or not properly seated. Replace and properly seat the bucket.
Other Features
• Bucket Full Light: Illuminates when the bucket is full and needs to be emptied.
• Auto Shut Off: The unit shuts off when the bucket is full, or when the bucket is removed or
not properly seated. Unit also shuts off when the set humidity has been reached. (The fan
will continue to run for additional 3 minutes then stop, unit will resume when ambient
humidity rises 5% above set humidity.)
• Auto Defrost: When frost builds up on the evaporator coils, the compressor will cycle off
and the fan will continue to run until the frost disappears.
• 3 Minute Delay: After the unit has stopped (or powered off), there will be a 3-minute delay
before it will resume operation again. This is to protect the compressor. Operation will
automatically start after 3 minutes.
• Check Filter Feature: The system begins calculating the time once fan motor begins
operation. The check filter feature will be activated when operation time achieves 250 hours
or more - the clean filter indicator light will begin to flash. After filter has been cleaned and
replaced, press the Filter button to reset and the clean filter indicator will go off.
• Auto-Restart: If the unit breaks off unexpectedly due to power cut, unit will resume at
previous setting when power returns.
• Timer On and Timer Off: Unit can be set to auto-start/stop, up to 24 hours:
o When unit is on: press of the Timer button and the Timer-Off indicator will illuminate
(indicating auto-stop is initiated). Press Timer button again and the Timer-On indicator
will illuminate (indicating auto-start is initiated).