Installation Guide

Installation Preparation
PREPARE THE LOCATION
DEPTH£24"(610mm)
WIDTH£18"(460mm)
HEIGHT£33"~35-1/2"(840~900mm)
UNIT DIMENSIONS
B) air gap with disposer
D) disposer
DEPTH£23"(580mm)
WIDTH£18"(450mm)
HEIGHT£33"~35"
(840~890mm)
Area of Plumbing and
Electric Service
6"
Floor must be Even
With Room Floor
Min. 18"
33 35-1/2" "
Underside of
Countertop to Floor
Min. 24"
Area of Pipe or wires
18"
Min.
33 ~35" "
18"
23"
When installed into a corner,
allow 2” minimum clearance
between dishwasher and
adjacent cabinet, wall or
other appliances. Allow 22"
clearance from the front
of the dishwasher for door
opening.
DRAIN CONNECTIONS
The type of drain installation depends on the answers to
the following questions:
18"
Min.
• Is air gap required by local codes and ordinances?
• Will waste tee or disposer connection be less than 18”
above the floor?
If both answers are YES, use method A or B. Otherwise
choose C or D.
A) air gap with waste tee
C) waste tee
Minimum Clearance 2"
22"
The dishwasher should be installed near a sink for
water supply connection and proper drainage.
A build-in dishwasher must be fully enclosed on
the top, sides and back, and must not support any
part of the enclosure.
2
CORNER INSTALLATION
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
If both answers are yes, choose A and B. Or you should
choose C and D.