Use and Care Manual

1. Unscrew the L-shape Bolt from bottom of the Extension Pole. (Fig.1)

2. Insert extension pole into the chassis, replace and tighten the L-shape Bolt. (Fig.2)

3. Loosen the height adjustment ring located on the extension and adjust the internal

pole to desired height. (Note: If you don’t see the internal pole, it is inside the

extension pole, simply pull it out.) (Fig.3)

4. Attach the head unit to the internal pole: loosen the thumb screw on the bottom

of the head unit. Place the head unit on the internal pole and tighten the thumb

screw in alignment with the groove on the internal pole. (Fig.4)

CAUTION: Height adjustment ring must be fully fastened before the assembly of the

motor section to the internal pole.

ASSEMBLY OF CHASSIS & COLUMN UNIT

Annular groove

Thumb screw

Loosen

Fig. 1 Fig. 2

Fig. 3 Fig. 4

1. Unscrew the spinner clockwise (this part may be packed separately in bag)

and unscrew plastic nut counterclockwise to remove. Fix the rear grill onto the

motor shaft, replace plastic nut and turn clockwise to tighten. (Fig. 5)

2. Insert the blade onto the shaft - make sure the rotor shaft pin is ﬁtted into the

groove on the blade. Turn the spinner counterclockwise to tighten blade. (Fig. 6)

3. Fix the front grill to the rear grill and secure with the grill clip. (Fig. 7)

GRILL & FAN BLADE ASSEMBLY

Blade Set

Clip

Fig.5

Fig.6 Fig.7