Instructions / Assembly

OVERHEAT PROTECTION OF THE MOTOR
HOW TO USE THE REMOTE CONTROLLER CORRECTLY
Point the remote controller at the receptor on the control panel of the fan and press
the desired button. The remote controller will work at distance of up to roughly 16
feet and the angle of 30 degrees to the left or right and left from the receptor.
A thermal fuse is installed in the motor that will prevent the motor from overheating
due to any unexpected reasons.
The fan requires little maintenance. Do not try to fix it by yourself. Refer it to
qualified service personnel if service is needed.
1. Before cleaning and assembling, fan must be unplugged.
2. To ensure adequate air circulation to the motor, keep vents at the rear of the
motor free of dust. Do not disassemble the fan to remove dust.
3. Please wipe the exterior parts with soft cloth with mild detergent.
4. Do not use any abrasive detergent or solvents to avoid scratching the surface.
Do not use any of the following as a cleaner: gasoline, thinner.
5. Do not allow water or any other liquid into the motor housing or interior parts.
MAINTENANCE INSTRUCTION
CLEANING
9
1. Be sure to unplug from the electrical supply source before cleaning.
2. Plastic parts can be cleaned with mild soap and a damp cloth or sponge.
Follow with clean damp towel to remove soap film.
3. Be sure water or other liquid does not come in contact with the motor.