INSTRUCTION MANUAL HOT WATER DISPENSER WITH MULTI-TEMP FEATURE Model: SP-3203 (3.2 liters) Model: SP-5020 (5 liters) Thank you for purchasing this appliance. Read all instructions carefully before use.
The important information, herein, is intended to prevent possible injuries and damage to the appliance. Please follow accordingly. General Safety Precautions Always unplug appliance from the main electrical supply outlet before cleaning or when not in use. Always attach the power cord to the appliance BEFORE you plug it to the main electrical supply. To disconnect appliance, grasp the plug to remove, do not pull on the cord.
Parts Identification Caution: Before use 1. Please read these instructions carefully before using and keep them for future reference. 2. Check and confirm the local main voltage is the same as stated on the appliance. 3. Handle power cord carefully. Do not bend or pull on cord. Unplug from wall socket when not in use. 4. Always use the dispenser in a vertical upright position. 5. Allow dispenser to cool before cleaning. 6.
How To Use Opening and Closing Top Lid To open: press down the Lid Lock with thumb and pull latch upwards. If unit was in operation, be cautious of hot vapor that may escape. To close: press lid down firmly. Make sure lid is securely closed or water will not reach set temperature and boil continuously. Make sure you hear a “click” when closing. Removing and Replacing Top Lid To Remove: Lift top lid to about 45° angle, press the Release button (located at the rear of the top cover) and remove.
Setting the KEEP WARM Temperature 3 temperature settings: 140°F, 185°F and 208°F. Press the “TEMP SELECT” button to select desired temperature, the corresponding indicator light will illuminate. This can be changed at any time. Unit will automatically switch to Keep Warm (at your selected temperature) after water has boiled. TEMPERATURE SETTING CHART 208°F Suitable for instant food and for hot beverag es such as chocolate drinks.
Care and Cleaning Disconnect power from wall outlet and allow appliance to cool before cleaning, remove cord from receptacle. Detach upper lid and pour out remaining water. Be cautious if water is hot. Do not wash under running water. Do not place in a dishwasher or dryer. Do not wet the control panel and receptacle. Do not leave water in pot unused for long period of time. Do not turn unit upside-down to dry. Do not immerse any part of the dispenser in water or any liquid.
Troubleshooting SYMPTOM Water does not boil when plugged in. (Power LED on) POSSIBLE CAUSE Dirty inner pot. Added water is already hot. Water level is below refill line. Unit may not function properly if used in high elevation or in very Unit will not switch to Keep cold or hot conditions. In such conditions, unit may keep boiling Warm or not reach boiling point. Unit will not switch to Boil Water level is too low. Dirty inner pot Unit not plugged in.
Your Guarantee If this product is found to be faulty as a result of faulty materials or Workmanship within one year from date of purchase, it will be repaired free of charge. This guarantee is subject to the following terms: • • • • • • • Sunpentown must be notified of the fault. Proof of purchase must be presented to Sunpentown’s nominated representative. The warranty will be void if the product if modified, misused or repaired by an unauthorized person.
