Automatic Flake Ice Maker Instruction Manual SZB-20 SZB-40 Thank you for selecting SPT Automatic Flake Ice Maker. Please follow and save this instruction manual.
Content Features………………………….1 Before First Use……………………………..1 Structure………………………………………2 Accessories…………………………………….2 Installation Instructions……………………………3 Maintenance………………………………3 Specifications…………………………….3 Troubleshooting……………………………..4 Circuit Diagram……………………………………..
Features: Stainless Steel front panel and flat door LED indicators on operation board Internal water storage tank for water preservation Insulated ice storage cabinet Gravity based draining Auto-cleaning function: Every time the unit is turned on, it will go through an auto-cleaning process. During this process, the 3 indicator lights (“RUN”, “FAULT” and “WATER LOW”) will flash at the same time.
Structure: 1. Power Switch 2. Display Panel 3. Ice Maker Door 4. Ice Outlet 5. Ice Full Sensor 6. Ice Storage Cabinet 7. Power Cord 8. Water Inlet 9. Drain Spout 10. Drain Outlet 11. Foot Accessories : Water Inlet Tube Water Drainage Tube Squeeze Hose Clamp Ice Shovel .2 .
Installation Instructions: 1. Unpack the ice maker and take out the attached documents and included parts, such as the water inlet and drain tubes, ice shovel and gaskets. 2. Install in the proper free-standing location. (See Before First Use) 3. Connect one end of the drain tube to the water outlet connector on the ice maker. Connect the other side to your drain or external condensation pump. (purchased separately from most hardware or plumbing stores) 4.
Troubleshooting: Trouble The ice maker does not work. “WATER LOW” indicator light is on. Compressor does not work. Compressor works, but no ice is made. “FAULT” indicator light stays on. “ICE FULL” indicator light flashes. “WATER LOW” and “ICE FULL” indicator lights flashes at the same time. “FAULT” and “WATER LOW” lights flash and the “RUN” light stays solid. Causes 1. The voltage is too low. 2. The ambient temperature is too low (lower than 41°F) 1. Water shortage from the water supply. 2.
Circuit Diagram .5 .
Your Guarantee If this product is found to be faulty as a result of faulty materials or workmanship within one year from date of purchase, it will be repaired free of charge. This guarantee is subject to the following terms: Sunpentown must be notified of the fault. Proof of purchase must be presented to Sunpentown’s nominated representative. The warranty will be void if the product if modified, misused or repaired by an unauthorized person.