Use and Care Manual

Features:
 Stainless Steel front panel and flat door
 LED indicators on operation board
 Internal water storage tank for water preservation
 Insulated ice storage cabinet
 Gravity based draining
 Auto-cleaning function: Every time the unit is turned on, it will go through an auto-cleaning
process. During this process, the 3 indicator lights (“RUN”, “FAULT” and “WATER LOW”) will
flash at the same time. This process takes about one minute
 Overheat protection: If the internal temperature is above 164°F, the unit will shut-off
automatically with “FAULT” and “WATER LOW” lights flashing and the “RUN” light staying solid.
The unit will resume operation when the internal temperature drops below 158°F.
Before First Use:
1. The unit should not be tilted more than 45° during transportation and unpacking. Do not turn
the ice maker upside-down as this may damage the compressor or refrigeration system.
2. The flake ice maker should be placed on a flat, level and firm surface away from any heat
sources or corrosive gas.
3. This unit is for Free-Standing use only. It vents from the sides. Do no place anything above the
unit or install under-counter. There must be at least 3 feet of clearance on each side and at least
6-inches behind the unit.
4. Wait 12 hours after installation before turning on the ice maker.
5. Unit is designed for use in a 3-prong grounded outlet. Do not use adapters to bypass this
feature.
6. If the power cord is damage, it must be replaced by a qualified person to avoid electrical
hazards.
7. Flake ice maker should be connected to a drinkable water supply only.
8. This appliance is not intended for use by children or other persons without assistance or
supervision if their physical, sensory or mental capabilities prevent them from using it safely.
Children should be supervised to ensure that they do not play with the appliance.
1
.
.
9. Please do not place the machine near flammable materials.
10. Use only new hose sets with the appliance. Do not use previously used hoses.