Use and Care Manual

- 10/12 -
Agitator
Nozzle base
Belt
Installing new belt:
Loop the new belt on the motor shaft; loop the other end of the belt on the belt
pulley on the agitator.
Insert agitator through belt and place belt in belt guide on agitator.
Should the agitator shield become dislodged while replacing the belt or the
agitator, reposition it noting the placement of its belt guide.
Securing agitator:
Grasp agitator firmly and fit it into position by first sliding end opposite the belt
into the rectangular slot on side of cleaner.
Pull other side of agitator into place. Turn agitator making sure the belt turns
freely and is not pinched between agitator and bottom of cleaner.
Replacing nozzle cover:
Turn over the cleaner and reposition cover. Turn to the bottom of the cleaner and
tighten screws securely.
PROBLEM POSSIBLE CAUSE POSSIBLE
Cleaner won’t run
1. Unplugged at wall outlet.
2. Tripped circuit breaker/blown fuse
at household service panel.
3. On/off switch not turned on.
4. Thermal protector tripped.
1. Plug in firmly, push on/off switch
to on.
2. Reset circuit breaker or replace
fuse.
3. Push on. off switch to on.
4. Reset thermal protector.
Poor job of dirt
pick-up
1. Full or clogged dust bin.
2. Wrong pile height setting.
3. Clogged nozzle or dust bin port.
4. Clogged hose.
5. Hole in hose.
6. Broken/misplaced belt.
7. Hose not inserted fully.
8. Motor protection system activated.
9. Dirty filters.
10. Sliders not rotating.
1. Clean dust bin.
2. Adjust setting.
3. Check clog and remove large
debris that has become lodged in
the airway.
4. Check for clogs.
5. Replace hose.
6. Replace/fix belt.
7. Insert hose fully.
8. Check for clogs.
9. Clean/change filters.
10. Remove obstructions.
Cleaner picks up
moveable rugs or
pushes too hard
1. Wrong pile height setting. 1. Adjust setting.
Agitator does not turn
1. Broken belt.
2. Belt installed incorrectly.
1. Replace belt.
2. Check belt changing and agitator
cleaning.
Air flow restricted and
it’s making wired
noise
1. Attachment used restricts airflow.
2. New carpet fuzz clogged air path.
1. Check attachment.
2. Remove clog in the base and clean
the hose.
TROUBLESHOOTING