Use and Care Manual

- 3/12 -

Before assembling vacuum, use parts list to verify that you have received all the components of your new cleaner.

HANDLE ASSEMBLY

Handle screw holes

Handle

Insert the screw so it passes through the handle into the vacuum.

Begin to tighten the screw with your fingers.

It may be necessary to adjust the handle slightly.

Using a screwdriver tighten the screw.

CAUTION

Do not over tighten.

Over tightening could strip the screw holes.

Do not operate the cleaner without the screw in place.

CORD ASSEMBLY

Make sure the quick release cord hook is in the upright position.

Remove the wire tie from the power cord.

Lock the cord into place by forcing it into the locking notch on the body of the

quick release cord hook as shown.

This helps to keep the power cord away from under the vacuum cleaner agitator.

Wrap the power cord around the quick release cord hook and lower cord retainer.

Lock the power cord plug onto the power cord.

TRANSPORTING AND CARRYING CLEANER

To move cleaner from room to room, put handle in upright position, tilt cleaner

back on rear wheels and push forward. Cleaner can also be moved by using the

carrying handle located on the top of the dust bin.

ASSEMBLY INSTRUCTION