Use and Care Manual

- 5/12 -
To select a carpet height setting:
For maximum cleaning performance, the following carpet height settings are
recommended:
 Lowest setting: for all types of carpet and hard surface flooring.
Note: If the cleaner is difficult to push, turn knob to the next higher setting.

Higher settings: for very deep pile carpet, where easier pushing effort is
desired, while maintaining good cleaning performance.
ATTENTION: Special care is required when vacuuming certain types of carpet
of floor covering. Always check the recommended cleaning instructions of the
carpet or floor covering before vacuuming.
To Select Suction Control:
Turn the Suction Control Knob to desire setting from MIN to MAX.
Release the handle by placing your foot on the pedal and pull back on the handle
until it releases from its upright position.
Pedal
To start the vacuum cleaner, step on the ON/OFF switch located on the back of
the vacuum. To stop the vacuum cleaner, step on the switch a second time.
CARPET
HEIGHT SETTING
AND SUCTION
RELEASING THE HANDLE