Use and Care Manual

CLOSE
OPEN
Operation
11
TIMER function
When the unit is operating:
- Press the TIMER button to program auto-stop, the
TIMER OFF indicator will illuminate. Press the + or -
buttons to set the time for unit to turn off.
- Press the TIMER button again within 5 seconds will
allow you to program auto-start. The TIMER-ON
indicator will illuminate. Press the + or - buttons to
set the time for unit to turn on.
When the unit is off:
- Press the TIMER button to program auto-start, the
TIMER ON indicator will illuminate. Press the + or -
buttons to set the time for unit to turn on.
- Press the TIMER button again within 5 seconds will
allow you to program auto-stop. The TIMER-OFF
indicator will illuminate. Press the + or - buttons to
set the time for unit to turn off.
- Press or hold the +/- button to change time in 0.5
hour increments, up to 10 hours; then in 1 hour
increments, up to 24 hours. The control panel will
count down the remaining time until program begins.
- The display will automatically revert back to displaying
the previous temperature setting if there is no activity
within a 5 second period.
- After time has been programmed, if unit is manually
turned ON or OFF; or if the timer setting is adjusted to
0.0, all timer programs will be cancelled.
- When unit malfunctions and error codes E1, E2, E3
or E4 is displayed, timer programs will also be cancelled.
Other features
Auto-Restart
If the unit breaks off unexpectedly due to power cut, it will
restart at previous function when power resumes.
Air Flow Adjustment (SWING)
- When the unit powers on, the louver opens fully.
- Press the SWING button to initiate the auto-swing.
The louver will automatically swing up and down.
- For xed angle, press SWING button when louver is
at desired angle.
NOTE: Please do not adjust the louver manually.
VENT CONTROL
The vent control is located at the back of the unit.
The OPEN position removes stale air from the room and
exhausts it outside. Fresh air is drawn in through
normal passages in the home.
When there is no need to circulate the room air, set
vent to CLOSE position.