Use and Care Manual

USING THE REMOTE CONTROLLER
R
emote Contr
oller Specifica
tions
Battery Required
AAA battery x 2 (not included)
Signal Receiving Range 8m
Operating temperature -5°C ~ 60°C (23°F ~140°F)
The design and specifications are subject to change without prior
notice for product improvement. Consult with the manufacturer for details

NOTE:
Buttons design is based on typical model and might be slightly different from

the actual one you purchased, the actual shape shall prevail.
All the functions described are accomplished by the unit, if the unit is not

equipped with a certain feature, there will be no corresponding action.
When there are wide differences between Remote controller Illustration and
USERS MANUAL on function description, the description on USERS
MANUAL

shall prevail.
The device could comply with the local national regulations. In Canada, it
should comply with CAN ICES-3(B)/NMB-3(B). In USA, this device complies
with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1)This device may not cause harmful interfe-rence, and (2) this
device must accept any interference received,including interference that

may cause undesired operation.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.Changes
or modifications not approved by the party responsible for compliance could
void users authority to operate the equipment.
15
ON/OF F
TE MP
SHORT
CUT
TIMER
ON
TIMER
OFF
MODE
FAN
LED
SLEEP
SWING