Use and Care Manual

Installation
6
Tools Needed
-Medium Philips screwdriver; -Tape measure or ruler; -Knife or scissors;
-Saw (optional, to shorten window adaptor for narrow windows)
Your Window Installation Kit ts windows 67.5-123cm(26.5-48”) and can
Accessories
be shortened for smaller windows.
Part
Description
2 pc
2 pc
2 pc
1 pc
1 pc
1 pc
1 pc
1 pc
2 pc
2 pc
1 set
1 pc
Unit Adaptor
Window Slider Adaptor
Window Slider A
Window Slider B
Exhaust Hose
Bolt
Foam Seal A (Adhesive)
Foam Seal B (Adhesive)
Foam Seal C (Non-adhesive)
Security Bracket and 2 Screws
Drain Hose
Quantity
Remote Controller
(2 AAA batteries required, not included)
Window slider B
Bolt
ON/OFF
TEMP
SHORT
CUT
TIMER ON
TIMER OFF
MODE
FAN
SLEEP
SWING
LED
Unit adaptor
Window slider adaptor
Exhaust hose
Exhaust hose assembly
Hook
Adaptor
Adaptor
Hole Seat
Hook
Groove
Make sure each adaptor is
inserted into the groove of
the air outlet.
Wall adaptor for through-the-wall
installation. (Not included, option to
purchase.) Please refer to page 8
for installation instructions.
Check all accessories are included in the package and please refer to the installation instructions
for their usage. Note: All illustrations in this manual are for explanation purposes only. Your air
conditioner may be slightly different, the actual shape shall prevail.
Window Installation Kit
Step One: Preparing the Exhaust Hose Assemblies
Press window slider adaptor and unit adaptor onto the
exhaust hose. Clips on the adaptors will automatically
clamp onto the exhaust hose.
Step Two: Install the Exhaust Hose Assemblies to the Unit
Align the hooks on the unit adaptor to the hole seat of the
air outlet (located on the back of the unit). Insert adaptor
and slide hose assembly downwards into the groove.
Step Three: Preparing the Adjustable Window Slider
Depending on the size of your window, adjust the slider kit
accordingly. If the window requires both pieces of the slider
kit, use the bolt to secure the length of the kit.
Note: If the window opening is less than the minimum length of the
slider kit, cut Slider A. Cut the solid end, DO NOT cut out the openings.
Window slider A