User Guide

LED status indicators
The following LED states are for a camera not connected to the PC.
l
Steady Yellow - The camera is in Video Mode 1 and is on standby.
l
Slowly flashing Yellow (1 sec. On, 1 sec. Off) - The camera is in Video Mode 1 and is
recording video. The Video Recording indicator (see configuration) must be ON for this to
work.
l
Steady Blue - The camera is in Video Mode 2 or Playback Mode (if an A/V cable is
connected) and is on standby..
l
Slowly flashing Blue (1 sec. On, 1 sec. Off) - The camera is in Video Mode 2 and is recording
video. The Video Recording indicator (see configuration) must be ON for this to work.
l
Steady Red - The Camera is in Photo Mode.
l
One Red/Yellow flash - The camera has taken a picture.
l
Steady Green - The battery is charging.
The rear LED
If the camera is configured to show the Recording Indicator, then the rear LED will normally blink in
sequence with the main LED while recording or in standby mode.
Connecting the camera to the PC
Make sure a card is inserted and the camera is turned OFF if you want to access the camera as an
external device (disk drive, setup). Always connect the camera directly to the PC. Do not use a
USB hub.
► You cannot record video or photos if the camera is connected to the PC as an external drive.
Charging
l
Connect one end of the supplied standard USB cable to the camera.
l
Connect the other end to a USB, 5V DC power source (wall charger, PC or external battery).
l
When the yellow LED turns on, press the Power button for about two seconds to turn the
camera OFF.
When charging, the green LED will be on. It will turn off when the battery is fully charged.
Charging takes about 2 hours for a fully discharged battery with the camera turned off and
connected to an external USB Charger. Batteries are not covered under warranty. If charged with
under-rated chargers or by using a USB hub without an additional power supply, expect longer
charging times. For optimum results, the charging voltage should be +5V under load. Only
use quality chargers capable of supplying 1000mA (1A) and a stable voltage of at least 5V. Low
quality chargers may not be able to supply enough current and can lead to premature battery
failure or, in the worst case, even destroy the camera.
A new and fully charged battery will record about 30 minutes of 1080p 60fps videos.
Automatic Power Off from Standby mode
If the camera is in standby mode you must take a picture(s) or start a video recording within *30
seconds. The camera will automatically turn off after *30 seconds of no activity.
*This value can be set using the setup program. Automatic Power Off can also disabled.
When the special A/V cable is connected, automatic power-off will be disabled. This prevents
signal loss during fpv use when the standby time times out.
Turn on Camera
Press the Power button until the LEDs begin to blink. The camera is ready for use once the Yellow
LED turns on. .
Turn off Camera
Press and hold the Power Button for about 3 seconds until the LEDs start to flash. The camera will
then turn off.
Instruction Manual Mobius Min... 3
10/21/2016 1:05:50 PM