User Guide

-> Video playback)
l
In Photo Mode, double-click the Shutter button to exit Playback mode and return to Video
Mode1.
l
Double-click the Shutter button to exit Playback mode and return to Video Mode1.
► Playback Mode -> Video playback
l
Press the Shutter button to pause/play the video.
l
Press the Power button to fast forward the video.
l Press the Mode button to reverse the video.
l
Long-press the Shutter button to exit Video playback Mode.
► In-Camera formatting is also available via the OSD menu.
► Also see Manual configuration under Camera Setup (Configuration), above
Firmware Update
New firmware versions usually correct issues found in previous versions but often provide new
functionality which was not previously available.
Use mSetup (Tools) to automatically update the firmware. This is by far the easiest method.
Manual Firmware Update
DO NOT PRESS ANY BUTTONS during the firmware update process.
There are two methods with which you can update the firmware.
Method 1 without pressing any buttons (recommended method):
l
Turn off the camera.
l
Connect the camera to the computer and wait until the card is recognized as a Removable
Drive.
l
Copy the new firmware files into the camera's flash card root folder.
l
Disconnect the camera from the computer and wait until it turns off.
l
Wait until all the LEDs are turned off.
l
Connect the camera to the PC. The green LED, indicating the battery is charging, may turn
on. WAIT.
l
The LEDs will blink rapidly indicating the firmware is being updated. WAIT
l
The firmware will be updated when the LEDs stop flashing and the camera is recognized as
a Removable Drive.
l
The firmware file will have been automatically deleted.
Method 2 by pressing the power button :
l
Turn off the camera.
l
Connect the camera to the computer and wait until the card is recognized as a Removable
Drive.
l
Copy the new firmware files into the camera's flash card root folder.
l
Disconnect the camera from the computer and wait until it turns off.
l
Wait until all the LEDs are turned off.
l Turn on the camera and WAIT.
l
The LEDs will blink rapidly indicating the firmware is being updated. WAIT
l
The firmware will be updated when the LEDs stop flashing.
l
The firmware file will have been automatically deleted.
l
The camera is now ready for use.
►After updating the firmware the date and time and all parameters will be reset to their default
values.
Recording using an ex ternal power supply
With the Mobius Mini, it is possible to charge the battery and record at the same time using a
standard external USB 5V DC power supply. The power supply may be mains driven (normal
household wall plug), or run off batteries, including the car charger USB plug (optional accessory)
and cable supplied with the camera.
External USB power supplies usually only use the +5V and the - (Ground) wires. The 2 data wires
are normally not used. However, some USB power supplies designed for a specific USB device
Instruction Manual Mobius Min... 6
10/21/2016 1:05:50 PM