User Guide

been configured to take Time-Lapse Photos with a time interval of less than 2 seconds.
Likewise, when Time Lapse has been set to less than 2 seconds, photos will always be
recorded without a time stamp.
FOV (Field Of View)
The field of view setting allows you to either capture the complete area of the image sensor
or a smaller area without noticeable loss in quality. The following table shows which area of
the image sensor is captured and how it is converted using the Wide and Narrow FOV
settings:
Resolution and
Frames per Sec.
FOV CMOS Area Explanation
1080p @ 30fps Wide 2304 × 1296
Reduced to 1920 × 1080 using pixel binning.
Widest possible setting
1080p @ 30fps Narrow 1920 × 1080
Captured directly from centermost portion of
CMOS array. No scaling
720p @ 30fps Wide 2304 × 1296
Reduced to 1280 × 720 using pixel binning.
Widest possible setting
720p @ 30fps Narrow 1920 × 1080
Identical to 1080p @ 30fps but reduced to 1280 x
720 using pixel binning
720p @ 60fps Narrow 1280 × 720
Captured directly from centermost portion of
CMOS array. No scaling. Narrowest possible
setting
Trouble shooting
Q. I can't take videos or photos and the camera is also not recognized by my PC as a
removable drive.
A. It's likely that the SD card is full or the file allocation table (FAT) has become corrupt.
Format your card using an external card reader or try another card.
Q. The camera is not recognized as a removable disk or as a Webcam.
A. The operating system must be XP or greater. The camera must be connected using a
standard USB cable. Confirm that the cable is not defective by attaching another USBdevice
using the same cable. Do not use a USB hub. Try using another USB port. Defective cables
are the most common problems when the camera is not correctly recognized by the PC.
Q. An SD card is installed, but the camera is not recognized as a removable disk or by
mSetup.
A. If you are sure your USB cable is not defective, then it's possible that the PC USB drivers
are not working properly. Try connecting the camera before turning on the PC. After the PC
is turned on, the camera should be recognized as a removable disk. DriveCleanup.exe
(freeware) may also be able to fix USB corruption problems.