User Guide

The camera is in Video Mode 1 and is on standby.
Yellow LED slowly flashes (1 sec. On, 1 sec. Off):
The camera is in Video Mode 1 and is recording video. The Video Recording indicator
(see configuration) must be ON for this to work.
Blue LED remains on:
The camera is in Video Mode 2 and is on standby.
Blue LED slowly flashes (1 sec. On, 1 sec. Off):
The camera is in Video Mode 2 and is recording video. The Video Recording indicator
(see configuration) must be ON for this to work.
Red LED remains on:
Camera is in Photo Mode or Playback Mode (if an A/V cable is connected) and is on
standby.
Red LED flashes once
The camera has taken a picture
Green LED is on:
The battery is charging.
The rear LED
When the camera is turned on, the rear LED will blink one to three times to indicate the
battery charge. Three blinks indicate a full battery, whereas one blink indicates the battery
charge is getting low. The blinks are fast. Slower blinks would unnecessarily extend the
time before the camera reaches standby mode. If the camera is configured to show the
Recording Indicator, then the rear LED will normally blink in sequence with the main LED
while recording. The rear LED will not blink when Photo Mode has been configured to take
Time-Lapse Photos with a time interval of less than 2 seconds.
Connecting the camera to the PC
Make sure the camera is turned OFF if you want to access the camera as an external device
(disk drive, setup). Always connect the camera directly to the PC. Do not use a USB hub.
Charging
Connect one end of the supplied standard USB cable to the camera.
Connect the other end to a USB, 5V DC power source (wall charger, PC or external