User Guide

page 14
VIDEO OUTPUT TO A TV
The Video-Out format parameter can be set to ‘Normal’ 16:9 or ‘Full Screen’. If set to
‘Normal’, the Video-Out image will be shown in its native 16:9 ratio. Some monitors will
show black bars top and bottom. If set to ‘Full Screen’, the Video-Out image will be shown
zoomed with the sides cropped from 16:9 to 4:3. How the image appears on the monitor
will also depend on how the monitor handles the video signal. This parameter may also be
set (and saved) during Video-Out preview as follows:
•
Make sure the image is visible on the monitor.
•
Double-click the power button to toggle the output between normal and full screen.
MOTION DETECTION
Motion Detection only works in video modes. It does not function in Photo Mode. When
Motion Detection is enabled, the Power-Off Standby timeout setting will be ignored.
The camera will, therefore, not turn off unless there is no power left to keep the camera
running, the memory card is full, or the camera is manually turned off.
When Motion is detected, the camera will start recording and the selected Motion Timeout
counter will be started. If no further motion is detected by the time the counter runs out,
the camera will save the recording and return to standby mode where it will wait for further
motion to be detected. If motion is detected while recording, the timeout counter will be
reset to the selected timeout.
The camera will continue recording until no more motion is detected and the timeout
counter runs out, the 4GB file size limit is reached, or the memory card is full. When the
4GB file size limit is reached, the current recording will be saved and a new one will be
started. There will be a 3-second gap between clips.
3 | camera setup