User Guide

page 18
TROUBLESHOOTING
The camera won’t power off.
Hold a pen or paper clip pressed into the recessed reset button until the LED returns to
standby mode or shuts off.
The camera won’t power on.
The battery needs to be charged (making sure that the USB cable is properly connected on
both ends) or the firmware has locked up. It the latter, press the reset button as above.
The camera turns on or a recording is in progress when the rear LED continuously
blinks very quickly.
The battery is nearly depleted and must be recharged.
When the camera turns on, the top LEDs blink (blue and yellow or blue, red and
yellow) and the rear LED blinks rapidly 20 times. It then turns off.
There is no microSD card inserted or the card is not making proper contact. Insert the card
and/or clean the contacts.
Trying to record a photo or take a photo is interrupted by the yellow and blue LEDs
blinking slowly about four times. The blinking rate then increases and the camera
turns off.
The card is either full (and loop recording is not turned on) or the card needs to be
reformatted.
4 | support