User Manual

Vibration-Trigger Sensitivity
You can set the camera to start recording when it senses a vibration, which may
be an appropriate use when placing the camera in an unattended vehicle. You can
set the level of sensitivity to High, Medium or Low. In a noisy environment like when
the car is parked on a busy street, set the trigger to Low Sensitivity. (Otherwise, the
camera might be triggered to record too much.) But in an isolated parking lot, set the
trigger to High Sensitivity. (That way it will pick up subtle changes.) If you’re not sure,
set it to Medium. You should experiment to see which setting is best in the intended
environment.
Once triggered, a recording will continue for 2 minutes, then return to standby until
triggered again. After choosing a vibration-sensitivity trigger in the Zetta Widget
software, make sure to click on Sync Settings to DVR and keep the camera’s
three-way switch in Custom mode. The Vibration trigger is disabled in Continuous
and Triggering modes. It’s set to High for high-quality video recording, Medium for
medium quality, and Low for low quality.
SPYTEC ZIR32 720P NIGHT VISION INTELLIGENT SECURITY CAMERA USER GUIDE 11
PIR Trigger
Thanks to the passive infrared (PIR) sensor, body heat can be used to trigger the
camera. However, unlike the camera’s other triggers, PIR sensitivity cannot be
adjusted. Select this trigger to record when body heat is detected. The camera can
sense body heat up close and to a maximum range 10 - 16 feet (3 - 5 meters).
Voice-Trigger Sensitivity
In the case of the camera’s microphone picking up a voice or voices to trigger
recording, you can adjust the mic sensitivity to High, Medium, or Low. If the goal is
to trigger a recording from people yelling or shouting, set the sensitivity to Low. If it
makes more sense to trigger a recording from people whispering, set the sensitivity
to High. If you’re not sure, set it to Medium. You should experiment to see which
setting is best in the intended environment.
Once triggered, a recording will continue for 2 minutes, then return to standby until
triggered again. After choosing a voice-sensitivity trigger in the Zetta Widget software,
make sure to click on Sync Settings to DVR and keep the camera’s three-way switch
in Custom mode. Voice triggering is disabled in Continuous and Triggering modes.
The Widget software’s voice-trigger is disabled by default.