Manualshelf

User Guide

ManualsBrandsSpy Tec ManualsCamera & PhotoSpy Tec Z12 Motion Activated Intelligent Security Camcorder Surveillance Camera
12345678910
Custom Mode, all custom settings will be disabled and recording resolution will be determined by
positioning the switch at On- the-go Mode (VGA) or Surveillance Mode (QVGA).
Frame Rate
You can choose to record video at a High frame rate (20 fps) or at a Low rate (6 fps). High is closer to
full motion, while Low enables longer-duration recordings. The Zetta Widget default frame rate is
High.
Indoor Lighting Condition
The camera can be set to match the frequency of electricity in various countries to provide the most
pleasing video under indoor lighting. For use in North America, the software should be set to 60 Hz,
though you’re unlikely to see much difference. The default is 50 Hz.
Day / Night Mode
Set to “Day mode” if the camera’s location offers adequate lighting. Set to “Night mode” for poor
lighting conditions. Set to “Auto” if the lighting condition will change while the camera is operating.
Make sure to click on Sync Settings to DVR and keep the camera’s three-position switch on Custom
mode. The default is Day mode.
Orientation
The camera can operate upside down. You may want to put this capability to use when finding an
optimum hiding position. That way, you can still have easy access to either side of the camera in a tight
corner. Resulting video will appear upside down on your computer unless you choose the Up-side-
down option in the Zetta Widget software. Make sure to click on Sync Settings to DVR and keep the
camera’s three- position switch in Custom Mode. The default is Normal orientation.
Time Stamp
Without doing anything, the video’s date and run time are superimposed by default along the bottom
right of the screen in the format: 2016/03/04 11:04:58 (year/month/ day hour/minute/second). This
allows you to identify the exact moment an incident occurred. However, if you prefer not to time
stamp the picture, click on the Disable button, then on Sync Settings to DVR. Make sure to keep the
slider switch on the camera in the Custom Mode position. The time stamp will not be recorded, and it
will not appear on the video.