LT-902VS Infrared Sauna Installation & Owner’s Manual Please read this entire manual thoroughly before proceeding with the assembly.
PRECAUTIONS AND INSTRUCTION SPECIFICATIONS ATTENTION Please read all instructions thoroughly before using. Serious injury may result if ignore the following warning and instruction. Basic precautions should always be followed when using this electrical equipment. DANGER To avoid the risk of causing burns, fire, electric shock, or other injuries: Connect the power cord to a properly grounded outlet. Using only for its intended use as described in this manual.
Step 1: Position the Floor Panel Attach Ceiling Panel to Front & Rear Panels Place the floor panel on a flat surface. Before assembly, make sure the floor is flat so that you can maintain a comfortable subsequent installation. (image1) There are 4 screws for fastening ceiling panel to front & rear panels. You could install the expansion screw at the Step 8.
CONTROL PANEL INSTRUCTION Main Power On/Off Temps Adjust Time Adjust Up to 149℉ Up to 60Mins Reading Lights On/Off Infrared Intensity Adjust 100% / 75% / 50% 9 Color Lights knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Using a sauna after taking alcohol, drugs, or medication can lead to hyperthermia and increase the risk of death.
Step 8: Install Ceiling Panel and connect the wires Step 6: Place the Bench Surface Panel Place the bench surface panel (image9), and connect the connecting wire of the light strip on the bench surface panel with the wire behind the bench support panel (image10). image 9 Place the ceiling on top of the sauna. Make sure that all panels are in the slots in the ceiling panel. Make sure that all wires on the side panel pass through the holes. Finally, connect all the wires in the ceiling panel.
Screw Fixation Step 4: Position the Right Side Panel Schematic diagram of expansion screw Place the right panel into the slot of the floor panel and push it towards the rear panel. Please check if there is almost no visible gap between the outside and the inside of the sauna, then it is already fixed. (image 4) You could install the expansion screw at the Step 1. It is installed to prevent wind.
