Product Manual

1008765 Rev. B7
12. Route the cable from the broadcast spreader to the
Cable Bracket that you assembled in the previous
step.
NOTE: Figure 12 shows the cable routing path
to the outside arm rest.
UTV
SUGGESTION
Route Beneath
Bed
Route to Arm
Rest
Figure 12
13. Pull the cable handle (F) out, and unthread the nut
(D) and lock washer (E) completely (See Figure 13:A).
Insert the Cable Bracket (4) between the nut (G) and
lock washer (E) into the groove of the Cable Bracket
(4) (See Figure 13:A).
Rethread the nut (D) and lock washer (E) onto the
Cable (6) (Figure 13:B) and tighten the Cable Bracket
(4) onto the cable until it looks like Figure 13:C.
Unthread
Completely
A
B
C
6
E
G
F
4
D
6
E
G
F
4D
6
E
F
F
4
E
Figure 13
Operation
Once the cable has been installed, you are ready to
spread. Set the Spyker dial to the desired setting. See
spreader Operator's Manual. Push the cable into the
cable housing to open the spreader. Pull the cable out
to close the spreader.