Operation Manual

24
MAIN MENU
Use the  and  buttons to navigate in the interface and to modify the selec-
tion. Use the OK button to select and the  button to return to the previous
menu.
SIGNAL
Allows the user to synchronize a new camera to a BLACKBOX
TM
-D
controller, see SYNCHRONIZE A NEW CAMERA TO THE CONTROLLER sec-
tion (p.26). Also allows to add other sets (camera/BLACKBOX
TM
-D) in a
same area, see USING MULTIPLE CONTROLLERS IN THE SAME AREA section
(p.26).
By default the TINY-W
3
camera, supplied with the BLACKBOX
TM
-D, is already
synchronized to the controller as CAMERA 01 in groupe 1 and the camera
icon is green. Each additional camera (TINY-PLUS) must be synchronized
with the BLACKBOX
TM
-D. To see the wireless signal icon on the main menu,
the WIRELESS option in SETTINGS should be on.
START BLACKBOX
TM
-D
Select this option when the controller and camera(s) have been con-
gured and synchronized. The controller is now ready to receive photos
from the synchronized camera(s).
SETTINGS
Allows the user to congure the different parameters of the synchro-
nized cameras.
1. When SETTINGS is selected, the complete list of options in the menu is
displayed. If more than one camera is synchronized to the controller,
choose the one that is to be changed.
2. Make the desired changes and press OK to conrm.
3. Press the BACK button to send the new parameters to the camera.
4. The message "Sending Settings" appears on the screen of the BLACK
BOX
TM
-D and the screen of the camera shows "Receiving". The controller
returns to the main menu when the changes are successful.
Setup • Controller (BLACKBOX
TM
-D
)
BLACKBOX
TM
-D AND CAMERA INSTALLATION
The strength of the wireless signal vary depending on the orientation of the
controller. We strongly recommend to install the controller on the same side
of the camera’s antenna (see gure below).
For best results, the antennas of the two devices must also point upwards
and their respective height should be approximately the same (see gure
below).
INSTALLATION WITH THE SUPPLIED STRAP
TREE
SIGNAL STRENGHT
SIGNAL
STRENGHT
Note: When the controller is left inactive for more than 2 minutes on the
main menu, it automatically resets itself to "START BLACKBOX
TM
" mode.
To return to the main screen, turn off the controller and turn it on again.
Note: When this option is selected, the controller screen turns off in order
to preserve battery life. To return to the main screen, turn off the control-
ler and turn it on again.
1. Insérez l’extrémité de la courroie dans la fente
qui se trouve au dos du mécanisme.
2. Insérez la courroie dans la fente sous le levier
et faites-la ressortir en arrière.
3. Créer une tension sur la courroie en la tirant vers
la droite, puis rabattez vers la gauche le levier pour
maintenir la position.