Installation Guide
Remove the existing load
center from the wall.
Using the Square D
Service Upgrade Load
Center as a stencil, mark
a “cut-line.”
Cut out the template
drawn on the drywall.
Be careful not to cut
existing wire.
Put an S-bend in the
wires that will enter the
bottom of the enclosure
and push them down into
the wall cavity.
Bunch the top-feed wires
together and feed them
through the holes in the
endwalls. Slide the
Square D Service
Upgrade Load Center
up into position (Easy!).
Reach through the holes
in the bottom endwall
and retrieve your
S-bent wires.
Step-by-Step