Manualshelf

Install Instructions

ManualsBrandsSquare D ManualsMotor Starters3-Pole Manual Switch, Toggle Operated, No Pilot Light Non-Reversing Motor Starter, 600 VAC (30A)
12345678910
Instruction Bulletin
Rev. 00, 39000-243-01 — 07/2018
Replaces 39000-243-01C — 08/2011
General Purpose Low Voltage Transformers
Indoor/Outdoor, Encapsulated, 600 V
Retain for future use.
© 2000–2018 Schneider Electric All Rights Reserved
ENGLISH
Introduction
This document provides installation, operation, and maintenance information for
Square D™ brand indoor/outdoor encapsulated transformers. The general purpose
transformers described in this bulletin are intended for power, heating, and lighting
applications under 600 V.
Safety Precautions
Receiving and Handling
Upon receipt, check the packing list against the equipment received to ensure the
order and shipment are complete. Claims for shortages or errors must be made in
writing to Schneider Electric™ within 60 days after delivery. Failure to give such
notice will constitute unqualified acceptance and a waiver of all such claims by the
purchaser.
Before returning any product to the factory, obtain a Return Material Authorization
(RMA) from your Schneider Electric representative.
Immediately inspect the transformer for any damage that may have occurred in
transit. If damage is found or suspected, file a claim with the carrier immediately
and notify Schneider Electric. Delivery of equipment to a carrier at any of the
Schneider Electric plants or other shipping points constitutes delivery to the
purchaser regardless of freight payment and title. All risk of loss or damage pass to
the purchaser at that time.
For details concerning claims for equipment shortages and other errors, refer to
Schneider Electric’s “Terms and Conditions of Sale.”
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH
• Apply appropriate personal protective equipment (PPE) and follow safe electrical work practices. See NFPA 70E.
• This equipment must only be installed and serviced by qualified electrical personnel.
• Turn off all power supplying this equipment before working on or inside equipment.
• Always use a properly rated voltage sensing device to confirm power is off.
• Do not apply transformers to circuits where system voltage exceeds nameplate rated voltage by more than 5%.
• Always apply over-current protection on ungrounded input and output conductors as detailed in Article 450 of
NFPA 70 (National Electrical Code
®
(NEC
®
)).
• Replace all devices, doors, and covers before turning on power to this equipment.
Failure to follow these instructions will result in death or serious injury.
WARNING: This product can expose you to chemicals including Phenyl
glycidyl ether which is known by the State of California to cause cancer. For
more information go to www.P65Warnings.ca.gov
.

Summary of content (12 pages)