Buying Guide

Three different semi-flush mounting depths
Semi-ush kit ca• n be installed to accommodate either 3-1/2, 4-1/2
or 5-1/2 in. stud walls
Various mounting depths also help conceal larger service •
entrance conduit
Dimension from ange to front of device is 2-1/4, 3-1/4 or 4-1/4 in., •
depending on location chosen for mounting anges
Top endwall knockouts behind ange are provided for branch •
wiring exit
Side anges run the full length of the enclosure•
FK400 Flange Mounting Kit
Overhead service trough accessory
Converts devices designed to only accommodate underground•
services for maximum application exibility
Trough is the same height and depth as the 400 A Combination•
Service Entrance Device (CSED) units
Cover is installed without screws and secured by a stainless steel •
latch at the bottom
Surface mount wire trough is located to the left side of the CSED•
unit and is adjacent to the utility pull section
Knockout in side wall of trough aligns with knockout provided in•
CSED pull box side wall (customer furnished box coupler and/or
conduit as required)
OCK400 Overhead
Feed Through
BMK2Q400 circuit breaker mounting kit
Mounting kit is used for eld-installation for two Q-Frame circuit •
breakers (order separately)
Includes two mounting pans, wires, pan mounting hardware•
and instructions
Installation requires moving the neutral and ground lugs•
Q-Frame circuit breaker information, two-pole, 200 A maximum•
QBL – 10 kA
QDL – 25 kA
QGL – 65 kA
BMK2Q400 Circuit Breaker
Mounting Kit