Installation Guide
Table Of Contents
- 40270-308-05_eng
- 40270-308-05_spa
- H1G-S Generic Topic 1st Level - Introducción
- PBB-S Begin Safety Statements Bulleted List - • Utilice equipo de protección personal (EPP) apropiado y siga las prácticas de seguridad en trabajos eléctricos establecidas por su Compañía, consulte la norma 70E de NFPA o Z462 de CSA y NOM-029-...
- H2G-S Generic Topic 2nd Level - Construcción de barras de dos hileras
- H2G-S Generic Topic 2nd Level - Construcción de barras de una hilera
- H2G-S Generic Topic 2nd Level - Retire las placas removibles de la cubierta
- H1G-S Generic Topic 1st Level - Preparación para la instalación
- NB-S Begin Numbered List - 1. Retire los discos removibles. Según el diseño de discos removibles, utilice un destornillador para hacer palanca y extraer los discos exteriores uno por uno hasta obtener la abertura necesaria.
- H2G-S Generic Topic 2nd Level - Cómo instalar un interruptor automático
- NB-S Begin Numbered List - 1. Desenergice (O/OFF) el interruptor automático.
- NC-S Continue Numbered List - 2. Inserte el extremo con terminal del interruptor automático en el gancho de montaje.
- NC-S Continue Numbered List - 3. Empuje el interruptor hacia dentro hasta que las mordazas enchufables encajen firmemente sobre el conector de barra.
- NC-S Continue Numbered List - 4. Instale los conductores.
- NB-S Begin Numbered List - 1. Desenergice (O/OFF) el interruptor automático.
- H2G-S Generic Topic 2nd Level - Identificación de los circuitos
- H2G-S Generic Topic 2nd Level - Cómo energizar el circuito
- H2G-S Generic Topic 2nd Level - Cómo desmontar un interruptor automático
- H1G-S Generic Topic 1st Level - Introducción
40270-308-05
Rev. 02, 04/2018
Replaces 40270-308-05 Rev. 01, 02/2014
Instruction Bulletin
Circuit Breaker Installation for Homeline
TM
Combination Service Entrance Devices
Retain for future use.
ENGLISH
™
Introduction
Homeline
TM
Combination Service Entrance Devices are designed to restrict
the installation of more overcurrent devices than that number for which it was
designed. Be advised that the plug-on connection arrangement for HOMT
circuit breakers is different from HOM circuit breakers.
Double Row Bus Construction
Tandem circuit breaker type HOMT may be installed in combination service
entrance devices where the bus bar connector has a slot at the centerline of
the desired pole space. See Figure 1.
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION OR ARC FLASH
• Apply appropriate personal protective equipment (PPE) and follow safe electrical work
practices. See NFPA 70E, CSA Z462 or NOM-029-STPS.
• This equipment must only be installed and serviced by qualified electrical personnel.
• Turn off all power supplying this equipment before working on or inside equipment.
• Always use a properly rated voltage sensing device to confirm power is off.
• Replace all devices, doors and covers before turning on power to this equipment.
Failure to follow these instructions will result in death or serious injury.
CAUTION
HAZARD OF EQUIPMENT DAMAGE
Do not use excessive force to install a HOMT tandem circuit breaker where no connector slot is
provided. See Figure 1.
Failure to follow this instruction can result in damage to the circuit breaker case.
ENGLISH
NOTIC
E