Brochure

PowerPact H-, J-, and L-Frame Circuit Breakers
Accessories for Micrologic™ Trip Units
110
02/2016 © 2011–2016 Schneider Electric
All Rights Reserved
L
For installation recommendations, see page page 156.
Battery Module
The battery module is a back-up supply for the external power-supply module. The input/output
voltages are 24 Vdc and it can supply power for approximately three hours (100 mA).
Pocket Tester
The pocket tester connects to the Micrologic trip unit test connector. It powers up the Micrologic trip
unit and the Ready LED. It supplies the screen, allows settings to be made using the keypad, and
provides thermal imaging inhibit functions.
The pocket tester runs off of two Alkaline AA batteries.
Isolated Modbus Repeater Module
Since Modbus interface modules (part number STRV00210) are not isolated, an isolated Modbus
Repeater Module needs to be inserted between the Modbus network inside the equipment and the
Modbus network outside the equipment.
Table 77: Power Requirements
Module
Typical Consumption
24 Vdc at 68°F (20°C)
Maximum Consumption
19.2 Vdc at 140°F (60°C)
Micrologic 5/6 trip units 30 mA 55 mA
BSCM 9 mA 15 mA
FDM121 21 mA 30 mA
IFM 21 mA 30 mA
Isolated Modbus Repeater Module 15 mA 19 mA
Battery Module
Table 78: Battery Module
Description Catalog No.
Battery Module 685831
Pocket Tester
Table 79: Pocket Tester
Description Catalog No.
Pocket Tester S434206
Table 80: Catalog Number
Description Catalog No.
Isolated Modbus Repeater Module STRV00211