Instructions / Assembly

ManualsBrandsSquare D ManualsElectricalMeter-Pak 125 Amp 2 Gang Ring-Type Meter Socket

73298-753-06

12/01

Lexington, KY, USA

METER–PAK™ Wireway, Catalog No. MP43X8PED

Ducto para cables METER–PAK™, no. de cat. MP43X8PED

Class / Clase 4141

Retain for future use. / Conservar para uso futuro.

Instruction Boletín de

Bulletin instrucciones

INTRODUCTION

This bulletin contains instructions for the installation of METER–PAK™

Wireway to METER–PAK devices manufactured by Square D. METER–PAK

Wireway can be used on the METER–PAK devices shown in Table 1. For

dimensions, refer to Table 1 and Figure 1.

Figure 1: METER–PAK Device Dimensions

Table 1: METER–PAK Devices

Catalog No. Wireway

Grade to

Device Bottom

Meter Height

Bottom Top

MP22-125

MPR22-125

MPH22-125

MP43X8PED 25 in. (635 mm)

42–1/2 in.

(1080 mm)

51–1/2 in.

(1308 mm)

Top meter height

Bottom meter height

18 in. (457 mm)

Grade to device

bottom

Grade

4141-9622

Summary of content (4 pages)

PAGE 1
Instruction Bulletin 73298-753-06 12/01 Lexington, KY, USA Boletín de instrucciones METER–PAK™ Wireway, Catalog No. MP43X8PED Ducto para cables METER–PAK™, no. de cat. MP43X8PED Class / Clase 4141 Retain for future use. / Conservar para uso futuro. This bulletin contains instructions for the installation of METER–PAK™ Wireway to METER–PAK devices manufactured by Square D. METER–PAK Wireway can be used on the METER–PAK devices shown in Table 1. For dimensions, refer to Table 1 and Figure 1.
PAGE 2
METER–PAK™ Wireway Safety Precautions 73298-753-06 12/01 SAFETY PRECAUTIONS DANGER HAZARD OF ELECTRIC SHOCK, BURN, OR EXPLOSION Failure to follow these instructions will result in death or serious injury. MOUNTING WIREWAY Before mounting the wireway, mount the MP METER–PAK meter center to meet the utility minimum and maximum meter height measurements. To mount the wireway to the meter center, see Figure 2. Figure 2: METER–PAK Wireway Installation METER–PAK Torque to 35 lb-in (4.
PAGE 3
73298-753-06 12/01 Este boletín contiene las instrucciones de instalación de los ductos para cables METER–PAK™ en los dispositivos METER–PAK fabricados por Square D. Los ductos para cables METER–PAK pueden utilizarse en los dispositivos METER–PAK que figuran en la tabla 1. Consulte la figura 1 y la tabla 1 para obtener las dimensiones. Dispositivos METER–PAK No.
PAGE 4
Ducto para cables METER–PAK™ Montaje del ducto para cables MONTAJE DEL DUCTO PARA CABLES 73298-753-06 12/01 Antes de montar el ducto para cables, instale el centro de medidores MP METER–PAK de acuerdo con los requisitos de mediciones de altura máxima y mínima de los medidores establecidos por la compañía suministradora. Para montar el ducto para cables en el centro de medidores, vea la figura 2.