Installation Guide

QO™ and Homeline™ Load Centers S1B33894

Instruction Bulletin 07/2012

ENGLISH

Enclosure Mounting

Surface Mounting (Indoor or Outdoor)

Secure the enclosure to the wall with appropriate fasteners. Use all pre-cut holes in the back of the enclosure for

mounting. See Figure 2.

Outdoor

1. Use the sealing gaskets provided if the mounting knockout locations shown in Figure 2 are used.

2. Use either one mounting hole at the top and two mounting holes at the bottom, or two mounting knockout

holes at the top and two mounting holes at the bottom. See Figure 2.

Surface Mounting

Temporarily position the enclosure with the centered tear drop hole. Secure the enclosure to the wall using the

four mounting holes.

Flush Mounting (Indoor Enclosure Only)

1. Remove the four small mounting knockouts on the side walls for securing to sixteen in. stud walls. See Figure 3.

2. Position the enclosure so that the front edge is flush with the finished wall.

3. Secure the enclosure to the studs through the small knockouts. See Figure 3.

Main Circuit Breaker or Main Lug Wiring

1. Pull the conductors into the enclosure. Use approved wire clamps, conduit bushings, or other approved

methods to secure the conductor to the enclosure and prevent damage to the conductor insulation.

2. Connect the main and neutral wires.

a. Install the main and neutral wires according to the wiring diagram on the load center.

b. Connect the service ground, equipment grounding wire, or both as required by the local electrical code.

c. Torque each connection to the value specified on the load center wiring diagram attached to the

enclosure.

3. If required by the local code, install the enclosed green neutral bonding screw through the hole in the neutral

bar. Thread the screw into the hole in the enclosure and torque to the value specified on the card shipped

with the bonding screw.

LINE

Figure 2: Surface Mounting Figure 3: Flush Mounting

Indoor

Outdoor

Mounting holes

Mounting knockouts

Mounting hole

Indoor Only

Mounting holes

Center

mounting

hole

Mounting holes