Instructions / Assembly

Circuit Breaker Load Centers 40269-469-02

Instruction Bulletin 03/2006

INSTALLATION AND WIRING BRANCH CIRCUIT BREAKERS

Installing Circuit Breaker

1. Turn OFF (O) circuit breaker.

2. Snap wire terminal end (A) of circuit breaker onto mounting rail (B).

3. Push circuit breaker inward until plug-on jaws (C) plug securely onto bus

bar connector (D).

4. Install wire(s).

Removing Circuit Breaker

1. Turn OFF (O) circuit breaker.

2. Remove wire(s).

3. Disconnect plug-on jaws (C) from connector by pulling circuit breaker

outward until it disengages from mounting rail (B).

Figure 2: Installing and Removing Circuit Breaker

WARNING

HAZARD OF EQUIPMENT DAMAGE

• This equipment is designed and tested by Square D

to performance levels which exceed

Underwriter’s Laboratories Standards.

• Use of other than Square D

circuit breakers may adversely affect user safety and impair

reliability. Schneider Electric disclaims all liability for damage, injury or non-performance caused

by the use or failure of non-Square D circuit breakers.

Failure to follow these instructions can result in death or serious injury.

11309617

40269-469-02.fm Page 2 Thursday, April 20, 2006 9:23 AM