Instructions / Assembly

40270-308-05 Circuit Breaker Installation for Homeline

Combination Service Entrance Devices

Rev. 01, 02/2014 Instruction Bulletin

ENGLISH

Prepare for Installation

1. Remove knockouts.

Appropriate to knockout pattern, drive center knockout inward or

outward. Alternately pry up or drive in outer rings one at a time to

opening required.

Figure 8:

2. Select the proper cable clamp, or use other approved methods for

securing the cable conduit to the enclosure.

3. Install and wire branch circuit breakers.

Circuit Breaker Installation

1. Turn off circuit breaker.

2. Insert wire terminal end of circuit breaker into mounting hook.

3. Push circuit breaker inward until plug-on jaws plug securely on to

bus bar connector.

4. Install wires.

NOTICE

CAUTION

HAZARD OF EQUIPMENT DAMAGE

Use only Homeline

circuit breakers and replacement parts with

this product. Use of other components voids the warranty, may void

the UL listing and may result in personal injury or equipment

damage. Refer to device markings for specific restrictions.

Failure to follow this instruction can result in personal injury

or equipment damage.