Getting Started Guide

MOUNT SQUARE REGISTER TO YOUR COUNTER WITH SCREWS
1. Pick a spot
Grab the mounting plate. Pick a spot on your
counter for Register, position the plate, and use
a pencil to mark the four screw holes on your
counter. Make sure the raised cleat is on your
side of the counter, not the customer’s side. Note:
Maximum counter thickness is 2 inches (50 mm).
3. Position properly
Position the mounting plate onto the holes you’ve
drilled, then inse a screw into each hole. From
the underside of your counter, place a thumb nut
onto each screw and tighten until the thumb nut is
flush against your counter.
2. Drill your counter carefully
You need a drill, a 3/16" (5 mm) drill bit, and the
included screws and thumb nuts. Use the drill and
drill bit to make the four holes you’ve marked for
the plate.
4. Twist and lock
Place Register onto the mounting plate with the
larger screen facing right. Make sure the cleat is
positioned in its slot. Turn Register 90 degrees
clockwise so it locks into place.
1
2