User's Manual

56
STRIDE2400 Terminal Station Setup Guide
3.3.3 Connecting the STS Power Pack Cables
All input and output cable connections are made on the terminal blocks located inside the
STS Power Pack. These terminal blocks can accept upto 14 AWG wire.
Cable access to the terminal blocks is through two locking cable entry glands located at the bottom right
of the STS Power Pack. After passing all cables through the glands, make sure the glands are tightened
fully to lock the cables in place and protect the STS Power Pack from the environment.
3.3.3.1 Connecting AC Power to the STS Power Pack
The AC power cord provided with the STS Power Pack is used to connect the STS Power Pack to an
110 VAC power source.
Requirements:
d Make sure that the power switch on the STS Power Pack is set to off (down position), before
making any wire connections.
E
To connect AC Power to the STS Power Pack
1. Connect the live (black) wire from the AC power cord to TB1-1 on terminal block AC IN.
2. Connect the neutral (white) wire from the AC power cord to TB1-2 on terminal block AC IN.
Included with STS Power Pack: AC power cord (10 ft. or 3 m)
Tools: Small flat-blade screwdriver