User's Manual

66
STRIDE2400 Terminal Station Setup Guide
3.3.4.2 Connecting the STS Backup Battery to the STS Power Pack
STS Power Pack is offered with an optional battery warmer. If your STS Power Pack is equipped with a
battery warmer, you will need to wrap the battery warmer around the battery and connect it to the STS
Power Pack.
Requirements:
d Make sure that the power switch on the STS Power Pack is set to off (down position), before
making any wire connections.
After connecting the STS Backup Battery make sure to power up the STS Power Pack, refer to
Section 3.2.4 on page 44. Failure to power up the STS Power Pack may drain the battery.
E
To connect the STS Backup Battery to the STS Power Pack
1. Connect the positive (red) wire from the battery to TB3-1 on terminal block BAT as shown in
Figure 3.20 on page 67.
2. Connect the negative (black) wire from the battery to TB3-2 on terminal block BAT.
To connect the battery warmer
1. Connect the positive wire from the battery warmer to TB2-1 on terminal block AC OUT.
2. Connect the negative wire from the battery warmer to TB2-2 on terminal block AC OUT.
Purchased from SR Telecom: STS Backup Battery
Tools: Small flat-blade screwdriver