User Manual

Complies with

ID A Standards

D A107248

HIDF16000136

Electronic Regulatory Compliance Manual

SRAM LLC certifies that this product and its packaging are in compliance with:

RE Directive, the Radio Equipment Directive 2014/53/EC

WEEE Directive, the Waste Electrical and Electronic Equipment Directive 2012/19/EU

RoHS Directive, the restriction of the use of certain hazardous substances in electrical and electronic equipment 2002/95/EC

REACh Directive, the Regulation on Registration, Evaluation, Authorization and Restriction of Chemical Directive 1907/2006/EC

Batteries and Accumulators and Waste Batteries and Accumulators Directive 2006/66/EU

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause

harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC

Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on,

the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

This device complies with Industry Canada’s license-exempt RSS standard(s). Operation is subject to the following two conditions: (1)

this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired

operation of the device.

The term “IC”: before the radio certification number only signifies that Industry Canada technical specifications were met.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée

aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage

radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.

RF Radiation Exposure Statement:

Models 00010, 00110, 00210, 12810, 12910, 13200, 00220, 12920, 13000, 13100, and 00500 have been tested and complies with FCC and IC

RSS 102 RF radiation exposure limits set forth for an uncontrolled environment when used with SRAM accessories supplied or designated for

this product. To satisfy IC exposure requirements, a separation distance of at least 20 cm must be maintained between the antenna of this

device and persons during device operation. The use of any other accessories may not ensure compliance with IC RSS 102 RF exposure

guidelines.

Declaration d'exposition aux radiations:

Les modèles 00010, 00110, 00210, 12810, 12910, 13200, 00220, 12920, 13000, 13100, et 00500 ont été testés conformemment aux normes

d'exposition d'emission RF de la FCC et IC RSS 102 pour un environement non controle lors d'utilisation avec les accessoires fournis or

recommendes par SRAM. Pour satisfaire aux exigences d'exposition IC, une distance de separation d'au moins 20 cm doit etre maintenue

entre l'antenne de cet appareil et des personnes pendant le fonctionnement de l'appareil. L'utilisation d'accessoires autres que ceux

recommendes par SRAM ne guarantis pas la compatibilite avec les normes d'emission RF de la IC RSS 102.

Warning: Any changes or modifications not expressively approved by SRAM could void the user's authority to operate this equipment.

This product is ANT+ certified and complies with the bicycle power ANT+ Device Profile. For a complete listing of ANT+ Certified Products

and their specific interoperability, please visit www.thisisant.com.