Instruction Manual

ManualsBrandsSREE Technology ManualsCamcordersWi-Fi Camcorder with LED light

INSTRUCTION MANUAL

Wi-Fi Floodlight Camcorder Instruction Manual

IMPORTANT SAFETY INFORMATION

IMPORTANT：Read these instructions carefully and look at the equipment to become familiar with it

before installation.

These instructions assume you’re replacing an existing floodlight and/or have a junction box where Floodlight

Camcorder can be mounted. If you don’t have a junction box, then you’ll need to hire a professional electrician to install

one or install the device.

In the use of the product,you must be in strict compliance with the electrical safety regulations of the nation and region

Please refer to technical specifications for detailed information

Disconnect power at the fuse or circuit breaker before installing.

NOTE:

◆ Do not handle any working device or attempt to turn on the power of the device with wet hand or while standing

on a wet or damp surface or in water.

◆Do not use the wires under excessive tension or compression loading

◆Do not use aggressive or abrasive detergents to clean body of the device

◆Verify that the supply voltage is correct. Connect fixture to a 100-240 V~ 50/60 Hz power source.

◆ Do not look inside the lights.

◆This product is fit for installations on garages, outdoor wall, house roof etc.

YR-001 泛光灯说明书

料号：1409020005

尺寸：A5 单面印刷

YR-001 泛光灯说明书

料号：1409020005

尺寸：A5 单面印刷

YR-001 泛光灯说明书

料号：1409020005

尺寸：A5 单面印刷

Summary of content (6 pages)

PAGE 1
INSTRUCTION MANUAL Wi-Fi Floodlight Camcorder Instruction Manual IMPORTANT SAFETY INFORMATION IMPORTANT：Read these instructions carefully and look at the equipment to become familiar with it before installation. These instructions assume you’re replacing an existing floodlight and/or have a junction box where Floodlight Camcorder can be mounted. If you don’t have a junction box, then you’ll need to hire a professional electrician to install one or install the device.
PAGE 2
◆if the product does NOT work properly ,please contact your dealer or the nearest service center. Never attempt to disassemble the camera yourself.
PAGE 3
E-yard For IOS E-yard for Google E-yard for Android 2. Wi-Fi Set Up Turn on the power of the camcorder, after a while, you will hear: System ready, the camera is now ready to begin pairing Remind: Make sure your mobile is near the device when it is pairing. And your mobile phone volume is ON When you hear Wi-Fi is connected, the last apps page below should be prompted, if not, it is normally because your Wi-Fi router has some delay, please reset your router and device to add device again.
PAGE 4
Follow the instruction of the device to set up Wi-Fi connection step by step. Or you can watch the video how to set up the camcorder Wi-Fi connection. Remind: The password needs to be with at least 8 digit including upper and lower letter and numbers.
PAGE 5
INSTALLATION WITH A JUNCTION BOX Note: Disconnect power at the fuse or circuit breaker before installing. 1.Installation parts display. 2.Mounting bracket to wall junction box. 3.The wire pass through EVA pad, and use wire nut to connect the junction box wire. 4.Lamp body is aligned with the hole on the bracket of the junction box, and use screw fixed in the middle of the bottom box.
PAGE 6
5.Plug the hole with a rubber plug, waterproof and dust proof. 6.refer to the picture below: loose the screws A and B, Adjust the heads of the lights to the direc tion you want. (it is upside down out of the box) and then tight the screws. Adjust the camera C t o the ideal direction, make sure the antenna is properly secured.