Users Manual Part 2

DECLARATIONS OF CONFORMITY
FCC Rules Part 15
The enclosed hardware device complies with part 15 of the FCC.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference and (2) it must accept any interference received,
including interference that may cause undesired operation.
FCC Compliance Statement:
This equipment has been tested and found to comply with limits for a Class B digital device, pursuant to
Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference in residential installations. This equipment generates, uses, and can radiate
Radio frequency energy, and if not installed and used in accordance with the instructions, may cause
harmful interference to Radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause interference to Radio or television equipment reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
1. Reorient or relocate the receiving antenna
2. Increase the separation between the equipment and receiver
3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
4. Consult the dealer or an experienced Radio/TV technician for help
To assure continued compliance, any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this equipment. (Example- use only
shielded interface cables when connecting to a computer or peripheral devices).
Caution! The manufacturer is not responsible for any Radio or TV interference caused by unauthorized
modifications to this equipment. Such modifications could void the users’ authority to operate the
equipment.