User's Manual
Table Of Contents
- 1 Notices
- 2 About your AIS class B transceiver
- 3 Installation
- 3.1 Preparing for Installation
- 3.2 Installation procedures
- Step 1 - Installing the Anti-Tamper Plate
- Step 2 - Installing the AIS transceiver
- Step 3 - Installing an optional external GPS antenna
- Step 4 - Connecting the VHF antenna
- Step 5 - Connecting the accessory cable
- Step 6 - Connecting an external switch
- Step 7 - Connecting to NMEA0183 compatible equipment
- Step 8 - Connection to an NMEA2000 network (optional)
- Step 9 - USB Connection (optional)
- Step 10 - Connecting to a power supply
- 4 Configuring your AIS transceiver
- 5 Operation
- 6 Anti-Tamper Configuration
- 7 Wi-Fi Configuration and Operation
- 8 Vessel Data Logger Configuration
- 9 Troubleshooting
- 10 Specifications
Installation
Page 20
Step 6 - Connecting an external switch
A toggle switch can be connected to the AIS transceiver to provide remote control of silent mode.
Connect the toggle switch between the light green and orange wires as shown in Figure 11. Connection of an external switch to toggle
silent mode is optional and not essential for normal operation of the product.
Figure 11 Connecting an external switch
Do not connect a voltage source across the switch inputs as this may damage the transceiver.
!
Transmit +
Transmit –
Power in +
Power in –
Switch input +
Switch input –
Receive +
Receive –
USB
Brown
Blue
Green
Orange
Red
Black
Purple
Yellow
NMEA0183
38,400 Baud
NMEA0183
4,800 Baud