User's Manual

Configuration using proAtoN
Page 47
8.5.2 ADC settings tab
This tab contains controls for the light current sense and ADC scaling parameters. There are three groups of
controls on this tab; 'Light Current Sense', Current Sense ADC Scaling' and 'Voltage Measurement Scaling'
(see
Figure 27).
Figure 27 ADC settings tab
Light Current Sense group
Checking the 'Enable Current Sense' box will enable the controls listed below. The function of each control can
be found in the corresponding command details.
● Current Sense Threshold (see 'isensethresh' in Table 6)
● Current Sense Source (see 'altisource' in Table 6)
● Light On Source (see 'lightonsource' in Table 5)
Current Sense ADC Scaling
These controls allow the setting of the scaling parameters for the two current sense sources. Details for these
parameters can be found in section
10.2.7. The underlying commands are 'setisensescale' and
'setaltisensescale' detailed in Table 6. Switching between these two sources is controlled by the Current Sense
Source control in the Light Current Sense group box above.
Voltage Measurement Scaling
These controls allow setting of the scaling parameters for the two voltage measurement sources. Details for
these parameters can be found in section
10.2.7. The underlying commands are 'setvoltscale' and
'setaltvoltscale' detailed in Table 6. Switching between these two sources is controlled by the Voltage
Measurement Source control of the Message Settings tab.