Programming Instructions

LD2342 V1.3 Page 8 of 21
SRT Marine
User guide
SRT-MTB
©
proAIS Application
Static Data Tab
This tab shows the current configuration of the AIS transponder and allows the configuration to be programmed during
installation into a vessel.
When an un-configured AIS transponder is connected for the first time the display will be similar to that shown below:
Configuring the transponder
To configure the transponder all of the data fields must be completed and saved to the AIS.



CAUTION:
For security reasons the MMSI of the vessel cannot be changed once programmed. Do not programme the
MMSI unless you are certain you have the correct information. Please check the number entered carefully. If
the MMSI programmed is incorrect the AIS transponder will need to be returned to the supplier for factory
reset.