SSD Diamond Enduro Axle Assembly

SSD Diamond Pro Enduro Axle Assembly Instructions
Note: The stock Enduro axles will need to be disassembled with all gears,
bearings and shafts removed before starting.
1 Install tubes into the housing
2 Install gears with the stock bearings
SSD-RC.com 1 Diamond Pro Axle for Enduro
3 Install third member
Be careful not to over tighten the screws
The front axle assembly (shafts, C-hubs, knuckles, link mounts) can
be completed in the same way as the stock axle.
Rear Axle Assembly
The rear axle tubes, gears, bearings and third member should be
installed the same way as shown in step 1, 2 & 3.
4 Use straight rear axle shafts and bearings.
SSD-RC.com 2 Diamond Pro Axle for Enduro
5
After axle assembly is complete they can be installed on the Enduro chassis
in the same way as the stock axles.
Recommended Parts
SSD00325 Pro44 Universal Axle Shafts
SSD00354 Brass Rear Axle Weights for Enduro
SSD00357 Heavy Brass Knuckles for Enduro
SSD00363 Brass Link Mounts for Enduro
SSD00376 Pro Aluminum C Hubs for Enduro
SSD-RC.com 3 Diamond Pro Axle for Enduro