Schematic

THIRD ANGLE PROJECTION
19 A/F
11.3
261 ±10
10
7.3
11.1
M12 x 1 - 8g
24 AWG PTFE WIRES
18.0
SEE TABLE
M12 x 1
TIGHTENING TORQUE:
1.5 NM / 13.26 IN-LBS MAXIMUM
OPTION 2. THREADED WALL
OPTION 1. CLEARANCE WALL
WASHER AND NUT OPTIONAL AND AVAILABLE ON REQUEST
SEAL WASHER
MIN. BEND
R6mm
17.3 REF.
10mm MIN.
5.10 MIN.
PROTRUSION
17 A/F
SEE TABLE SEE TABLE
18.0
12.20
SEAL WASHER
NUT
TIGHTENING TORQUE:
1.5 NM / 13.26 IN-LBS MAXIMUM
MAX TANK PRESSURE
7 BAR / 101 PSI
MAX TANK PRESSURE
7 BAR / 101 PSI
RECOMMENDED MOUNTING POSITIONS
OPTICAL LIQUID LEVEL SWITCHES SHOULD BE MOUNTED FROM THE SIDE OR FROM THE BOTTOM FOR BEST RESULTS. •
DO NOT ALLOW TIP OF SENSOR TO BE WITHIN TANK WALL. LIQUID CAN BE HELD IN WALL GIVING FALSE RESULTS •
AVOID MOUNTING POSITIONS WHERE AMBIENT LIGHT IS LIKELY TO POINT DIRECTLY AT THE SENSING TIP, AS FALSE READINGS CAN OCCUR. •
AVOID REFLECTIVE SURFACES WITHIN 10mm OF SENSING TIP. SWITCH PERFORMANCE CAN BE AFFECTED BY REFLECTIVE SURFACES •
MOUNTING FROM THE TOP DOWN IS NOT NORMALLY ADVISED AS FALSE READINGS CAN BE CAUSED BY LIQUID DROPLETS CLINGING TO THE SENSING TIP. •
HOWEVER, IF THE LIQUID VISCOSITY IS LOW, THEN POINTING DOWNWARDS IF OFTEN FINE. ADDITIONALLY, IF THE APPLICATION IS A HIGH LEVEL ALARM AND
ITS ACTIVATION RESULTS IN THE MACHINE SHUTDOWN FOR EXAMPLE, POINTING DOWNWARDS MAY BE ACCEPTABLE.
IF YOU REQUIRE MOUNTING IN ANY POSITION THAT IS NOT NORMALLY ADVISED PLEASE CONTACT [e-mail] TO DISCUSS THE IMPLICATIONS.
UNLESS OTHERWISE SPECIFIED
DIMENSIONS ARE IN MILLIMETERS
STANDARD TOLERANCES:
X X.X X.XX
0.5 0.2 0.1
DEBURR AND BREAK SHARP EDGES
ALL PARTS TO BE CLEAN AND FREE
FROM DUST & OIL
REVISION.
TITLE.
DRAWING NO.
SHEET 1 OF 1
LLX1X0D3X
LLX1 OPTOMAX DIGITAL - M12
MOUNTING
1
DRAWN ON. 15/01/2018
DRAWN BY.
S.McCURRACH
SCALE. 2:1
A3
MATERIAL:
LLC - POLYSULFONE
LLT - TROGAMID
A A
B B
C C
D D
E E
F F
8
8
7
7
6
6
5
5
4
4
3
3
2
2
1
1